|
Amazon offers SmallRig Full Camera Cage for Sony Alpha Cameras for with free shipping. Product Features:-
Improved Design: 1. A cold shoe is added to the upper right corner of
the cage to facilitate the installation of accessories such as
Microphone 3468 and LED Video light 3286; 2. Two 1/4"-20 threaded holes
with a spacing of 18mm are added at the bottom, which is compatible with
SmallRig Quick Release Plate for Arca 3154. A QD hole is added at the
bottom, which is compatible with QD quick release shoulder straps and
other accessories.
-
For Sony A7R V/A7 IV/A7S III/A1/A7R IV: SmallRig Cage 3667 is designed
for Sony A7R V, A7 IV, A7S III, A1, A7R IV to facilitate low-angle shots
and protect the camera while offering a wide range of accessory mounts.
NOTE: The Cable Clamp for HDMI 3000 is not compatible with Alpha 1 and
Alpha 7R IV because it will block the synchro terminal interface when
used on the Alpha 7R V.
-
Multiple Mounting Points: The cage has multiple 1/4"-20 holes and
3/8"-16 positioning holes for ARRI, which can attach accessories such as
the upper handle 3765, the side handle 2093, and the monitor stand
2903B. There are 2 built-in cold shoe interfaces, which can install
microphones, fill lights and other equipment; the QD hole at the bottom
is compatible with QD shoulder straps. Holes are reserved on both sides
and bottom of the cage to attach Wrist Strap PAC2456 and Shoulder Strap
PSC2428.
-
Three-Point Locking: A positioning pin is added at the bottom of the
cage, and the 1/4"-20 screw and the left M2.5 screw form a three-point
locking to make the camera stable. Adjust the direction of the left
locking slider to adapt to different models, [A7 IV] side is suitable
for Alpha 7 IV and Alpha 7R V, [A7S III/A1] side is suitable for Alpha
7S III / Alpha 1 / Alpha 7R IV
-
All-Round Protection: Built-in all-round rubber gasket to prevent
scratches. With the cage installed, the camera interface, dials, buttons
and changing batteries are not affected. The opening and closing wrench
design is added to the position of the battery compartment, which fits
the curve of the fuselage more, solves the problem of placing the little
finger, and enhances the grip of the fuselage.
-
Built-in Quick Release Plate: The bottom quick release plate for Arca
has added 1/4"-20 holes with a spacing of 18mm, which is compatible for
DJI RS 2 / RSC 2 / RS 3 / RS 3 Pro, and can also be adapted to DJI RS 2 /
RSC 2 stabilizer mounting board (riser plate) and SmallRig Quick
Release Plate for Arca 3154.
-
Power Backup Solution: SmallRig NP-FZ100 camera battery charger set is
available now, two 2040mAh(Real) rechargeable batteries and a charger
brings long battery life for your videos and photos shooting, if you
need a sufficient power supply, please search SmallRig NP-FZ100 Battery
3824(Asin:B09Z6TRBH8).
Category: Cameras
Posted on 11 July 2025, 10:33 AM
|
